need a new shift lever - advice

[thejackrabbit]

I have a Emgo shiftier on my bike now and it seems to wear out and get sloppy after every ride and filing the gap to get it tight again, and now its pretty much clapped out.
http://www.gofastersoffroad.com/Emg...71&browse=-37731&shopBy=-8817&catalogId=-2231

I was looking at the TMV shiftier as a replacement. any experience with them?

http://www.ktm-parts.com/16020334.html#.UzCWGPldWSo

 

[hamilton]

I installed a TMV shifter on mine, seems ok so far. It was rubbing on ingition cover as delivered, had to put in vise and bend slightly to clear cover.

 

[thejackrabbit]

my emgo shiftier already rubs on the ignition cover currently, so that's not a big deal. probably should have bent it out.
so on the TMV are the splines holding up well?

 

[hamilton]

Only have three races on it, so far so good. Just make sure the shaft splines are clean and loctite on the bolt

 

[Greco]

Does anyone make a slightly longer shifter? Mine is painfully close to the foot peg. '13 ec250. I don't have big feet (11) really, but the lever seems really short. My '02 xc250 was just fine. I checked both links above and I don't see where these are any different than the stock length.

 

[gasgasman]

The 125 shifter is longer.

 

[motopsycho87]

I always put threadlock on the splines and on the pinch bolt, hasn't come loose in a year.