powervalve spacer clearance

[Adam500]

I have a Christini AWD with 2015 300 engine and E start in it.
I wanted to try the power valve spacer. How wide are they?
It looks like it be very close to hitting the starter if it were spaced out more than a half inch or so.
Do they fit the newer engines with E start?
Thanks.

 

[philm]

I have a Christini AWD with 2015 300 engine and E start in it.
I wanted to try the power valve spacer. How wide are they?
It looks like it be very close to hitting the starter if it were spaced out more than a half inch or so.
Do they fit the newer engines with E start?
Thanks.

I don't believe that they fit the newer e start models. You might be able to get a thin one machined to fit but it might not make much of a difference.

Sent from my Moto G (4) using Tapatalk

 

[Zman]

You can always bump your ignition timing a few degrees for free. That will give you more bottom end and midrange. Listen for knock just in case but I have not had a problem with this on any of my bikes.

 

[SpirosZ1000]

I have the spacer sold from motocrosscenter in my 2015 300 e start and it fits just fine.No problem with the starter at all.

 

[john r b]

I have the spacer sold from motocrosscenter in my 2015 300 e start and it fits just fine.No problem with the starter at all.

Spiros, the '15 has an adjustable PV Have you adjusted this first before installing the spacer?

 

[SpirosZ1000]

Yes I have adjusted the pv.I have turned the screw from 2 turns out (standard) to 2,5 turns out because I want a more aggressive throttle response (like my 06 300 had )
Apart from that the spacer will benefit you in low revs whatever setting you choose for the pv.

 

[Adam500]

So the spacer from checkpoint offroad DOES fit the 2015 300 engine with the e start. BARLEY!!! But it does!
Noticed absolutely no difference in power at all.