Style of connector

[Bailey28]

Hey guys, I've been looking to add turn signals to my '10 EC300. I have the US bike that has several wires wrapped up in the airbox and by the front headlight.

I have in place the headlight, Sicass brake/tail light and the factory toggle switch. I really was wanting only front turn signals.

I looked and there are these funny two pin grey connectors that are very small. What type of connector is this? Is there a specific name for them? I don't want to go cutting and splicing if I don't have to, I would prefer to plug and play with as little intrusion as possible. Assuming these are the turn signal connectors of course.

Any help would be awesome!

 

[Bailey28]

OK, I looked at the wiring closer. In the front, I have a single spade connector with a white wire, another single spade with a yellow wire, and a 2 pin black and red wire connector. There is also a single round brass bullet style connector with a gray wire. All of these are "open" and are just tucked in with the headlight wiring. They are not connected to anything.

The parking light which has a 2 pin black and blue wire is not connected from where it comes out of the headlight pod.

In the airbox, I have only the black and purple 2 pin connector that is wrapped up, it is a very long wire. The 3 pin connector with the purple, white, and green wires are connected to the brake/tail light.

I do not have the factory turn signal/headlight/horn switch. I read in the manual from the scematic that the red/black may be the horn, and the others don't make any sense. Maybe the factory switch has the appropriate colored wiring on it, and these just feed into the switch?