Recent content by Cstewa37

Cheers all, thought I best check before ordering up parts. Yz250 front end you say...? 🤔 Chris

Hi all, Trying to work out what model of forks I have on my 2011 ec 250. Marzochis with the attached top cap. Is this likely to be the 45mm or 48mm? 🤔 Regards Chris

Still available?

Hi all, Selling my STIC metering block, purchased from Tokyo Offroad a few months back. It was on a recently rebuilt 250 which has ran for just over an hour. As new condition and comes with a JD jetting kit. Bought for $490 (?405), looking to sell for approx ?300/$375, can post anywhere once...

2011 Gas Gas EC 250 for sale. I bought the bike back in Dec 2021 and have spent the last 6/7 months rebuilding it to a high standard with no expense spared. The frame has been stripped and powder coated, Cylinder has been replated, New Wiseco piston and rings, Gaskets, Bearings, Rebuilt keihin...

Problem solved, just me being a tool. Chris

Awesome that's exactly what I need, thanks dude!!! Chris

Thanks Neil, that's a great start! You've got A LOT more wires at the headlight area than mine, maybe because mine is non estart and has no turn signals? Any chance you have a photo of the wiring from the stator going to the CDI and how it loops around the tank? My loom (a new GG replacement...

Hi all, Could anyone share some photos of the wiring route on a 2011 EC? Trying to work the wiring around where the fuel tank sits, but also where the main loom joins the lightswitch and headlight etc. Cheers Chris

EDIT Never mind, think I've sussed it! Chris

Oh excellent! Thanks for sharing, that definitely explains the issue haha! Even the reg is different from yours, this project is full of surprises! 😂 Chris

Hi all, Trying to rebuild my project bike back to factory as the previous owner has made a bit of a mess with it, the electrics in particular. The ignition coil when I bought the bike was in a vertical position and only attached with one bolt (see attached photo). Assuming this is incorrect...

SS109 superb, many thanks!! They'll definitely be going nice and high in that case haha! Chris

Hi all, stumbled upon an issue today after rebuilding my engine. Currently reassembling my 2011 EC 250 and I'm stumped where these two nipples connect to anything, and can't see where the original hoses go in photos that I took. I presume they're breathers of some kind, but can anyone tell me...

😂😂😂🙌 Chris