Recent content by krazy

see classified http://www.gasgasrider.org/forum/showthread.php?t=25947

SOLD - 2001 EC300 project for sale, plus parts/spares £500 Good condition, but I took apart few years ago to replace crank seal, which I did, and planned to give a thorough clean and going over but it never happened. I don't ride off road any more so selling as is. * V5 * New vertex piston...

Did you find the issue? If not I would say monitor tranny oil level as well in case of RHS crank seal leakage. Mine would suck oil at high RPM.

Hi, Per the video the actuator stays open if i slowly move the plate, but if i move it sharply and let go it does snap shut. Is that normal behaviour? Would i use the right screw near my finger to adjust the arm up further? I also want it to open sooner in general, so which of the shims...

Howdy, After my tuner did the porting and head work i never bothered to look at piston height at bdc. It might actually go a hair lower than the pic, but would this be considered as good as flush or is there more top end to be had. Two green gaskets used, i assume gasgas oem ones, .3mm...

Ok cool, i work around there often, been to Tong offroad in bradford. The pilot might be close but i would start with 182 or 185 main as n3 goes lean towards WOT. I am 38, n3ew , 185 but 182 is probably better after i fix my seal. Sent from my SM-N910F using Tapatalk

Can u video it for us? Just guessing here but What about the slide sticking on the way down? Might be gummed up or something. Try wacking the throttle a bit after a WOT run. Maybe try lowering the idle screw so it just barely idles, or doesnt even idle, and try that. Sent from my SM-N910F...

http://www.gear4motorcycles.co.uk/?i=116077 Try an N3 range needle, consensus on n1 is crap. There are some decent suppliers in UK, some parts crossover to KTM and such. Where are you?

Ah yes, i get ya. I was gonna use one of the hacky methods but i agree the proper tools save a lot of blood and tears. Ive read so many jakobi-the-jetter threads i almost feel guilty taking advantage of more free knowledge. Thanks for the tips. Sent from my SM-N910F using Tapatalk

Ha ha, sounds like something i would do. Sent from my SM-N910F using Tapatalk

Cool thanks Sent from my SM-N910F using Tapatalk

Thanks for the reply. You mean i need a 30mm wrench instead of a 30mm socket for the clutch basket nut? Maybe i should invest in an airgun, i love power tools but was trying to keep costs down. Thanks for the basket position heads up, wouldnt have known. The nearest manual i can find is for...

Hi, First time going insude a motorcycle engine. Just want to make sure ive got things straight. Ive ordered: RHS crank seal O-ring, not sure of the name but people mention it and gasgas uk said they knew what i was talking about. Big clutch gasket Small round clutch gasket Water pump...

Hi, I am near Hull also, North Newbald. Did you ever find a good spanner in the yorkshire area? I may need bottom end help at some point. I can do jetting, is your new bike dialed in? -Ryan

Crank seal?? Just an update, I've got the n3ew installed, and after lots of clearing out it runs pretty good. But something wasn't quite right. Then I noticed I am losing some gearbox oil. I'm pretty sure that is what's happening anyway, possibly right side crank seal from what I can gather...