2007 ec300 No lights

[Lostcause]

Hi!
I have a 2007 ec300 which I put away a couple of months ago due to a shiny new bike & it was working perfectly, now I've dug it out to check over & prep for a mate to have a play and there are no lights at all! The garage is slightly damp (just incase there's anything known to suffer)...
The regulator has had a hard life so I put a new one on for good measure & this has made no difference.
I read around 35v ac on the yellow wire from the stator, same at regulator & same on the headlight connector.
I can see nothing obvious, the headlight works fine off a battery. I've tried the headlight on bike without the tail light connected & vice versa with no joy.

Any suggestions or any common issues to look for?

Cheers- Steve

 

[SS109]

Check the light switch. The contacts in them can get corroded when sitting. I've had to clean more than one of them to get them to work.

 

[Lostcause]

All sorted

Thanks.
Turns out it was a bad ground connection due to fresh powder coating on the frame. I should've checked that sooner but it didn't occur to me initially since all had been working fine

 

[SS109]

Glad it was a simple solution!