99' EC200 Clutch M/C
- Thread starter 12Bravo
- Start date
12Bravo
New member
That was fast.......I haven't even pulled Ebay up yet.
I think I am going to just order that $70 one and be done with it.....But after shipping it will be $100.
Are there any new ones that will fit? Will a Brembo work? I have found some AJP, but it is on a trials site, will those fit my bike? It was $130 new, I can pay the extra $30 and have a new one. If not, I will just get a used one.
Thanks
12Bravo
New member
http://www.oppracing.com/product_di...ster-cylinder-ps13-black-wreservoir-wlever50/
Anyone know if this will work on my bike?
I got my M/C front brake from them, good company with fast shipping.
Anyone know if this will work on my bike?
I got my M/C front brake from them, good company with fast shipping.
12Bravo
New member
http://www.clake.com.au/product/one-light-clutch/
Wish I had the coin for this!
Half tempted to sell some of these extra parts I have to pay for the repairs. Waiting till mid-November to ride again doesn't sound fun at all!
I'm hooked I have the bug!
Wish I had the coin for this!
Half tempted to sell some of these extra parts I have to pay for the repairs. Waiting till mid-November to ride again doesn't sound fun at all!
I'm hooked I have the bug!
12Bravo
New member
The good, I have the M/C installed.
The Bad it drags, when bike is running I can hold the clutch in and bike doesn't lunge. However with bike off and in first gear, clutch pulled in bike won't roll. It drags the tire or rolls very hard with a skid the roll a bit the skid then roll a bit again.
Does anyone know where I can get the M/C dust cover? The little rubber piece the covers the plunger from getting dirt in there. Mine is missing, I didn't notice when I ordered the replacement.
Thanks
The Bad it drags, when bike is running I can hold the clutch in and bike doesn't lunge. However with bike off and in first gear, clutch pulled in bike won't roll. It drags the tire or rolls very hard with a skid the roll a bit the skid then roll a bit again.
Does anyone know where I can get the M/C dust cover? The little rubber piece the covers the plunger from getting dirt in there. Mine is missing, I didn't notice when I ordered the replacement.
Thanks
David Podyuchenko
New member
Can anyone help me? I've been searching for a while now... I have a 97 gasgas ec250 and my clutch slave main bolt connection where the banjo bolt screws in stripped. The slave thread stripped, banjo bolt is good. Any advice?
Anders
Gold Level Site Supporter
farmerj
Platinum Level Site Supporter
Loctite Form-a-Thread might be worth trying (I haven't).
Jeff
https://www.napaonline.com/en/p/NCB28654
Jeff
https://www.napaonline.com/en/p/NCB28654
