Crank Remover and Crank Installer tools for EC250

[Fabry]

Can anybody please point me to some good Crank Remover/installer tools that works with Gas Gas 2 strokes?

 

[Jakobi]

Tusk (rmatv) sells one, however I never required one when I did my bottom end. The cases split easy enough (once all the bolts are out). If the crank doesn't come out a few taps with a plastic/rubber mallet moves it easy enough. For installation I simply froze the crank with some dry ice and it dropped right in.

 

[pscook]

I didn't have to use any install tools, are you having issues? I know that motion Pro makes a very nice press and puller, they are affordable and pretty stout. But, again, I haven't had any issues installing a crank into the bearings if you freeze everything before installation.

 

[Fabry]

I didn't have to use any install tools, are you having issues? .......

I didn't start the job yet I'll like to line up with all I need (or may need) before start, this is only my second Crank rebuild i did an old XR250 once and it wasn't easy...
Thanks for the tips.

 

[pscook]

Check out Jakobi's rebuild thread here, he sorted everything out pretty well (two or three times in places ).

 

[Jakobi]

True that! That was my first ever bottom end. Learnt a few things.. Next one will be a walk in the park.