HELP power valve leaking

[Hellcat]

What did your figure out.

 

[spinisking]

Nothing yet the power valve part has not arrived I'm hoping tomorrow this is my 1st day off this week I will keep you posted once I have part.

I have checked all PV parts and rest is fine and all set up correctly as far as I can tell from manual.

If I start bike remove PV arm and moved PV manually that would tell me if it's pv or not?

 

[Hellcat]

It might but you would have to rev the engine and open power valve at same time and not positive if you can time it all correct . But could try or just wait for lever . Don’t forget new lock nut with the teflon and washer . Make sure linkage rod is not in bind when you tighten it all

 

[spinisking]

It might but you would have to rev the engine and open power valve at same time and not positive if you can time it all correct . But could try or just wait for lever . Don’t forget new lock nut with the teflon and washer . Make sure linkage rod is not in bind when you tighten it all

I was thinking close valve rev it till it chokes then open valve a little see if it changes it's tune and I have new nylock nut and washer thanks

 

[spinisking]

So while replacing the actuator part (came today old one in photo ) I noticed still not perfect done ABIT more research and the idiots have welded the arm on backwards so it's hitting the side of hole arm goes through found one online going to try pick it up this weekend.