Home made PFP adjuster tool.

[gasgasman]

I made my own PFP adjuster tool.

Our friendly MAC Tool guy came by the shop today. I saw an 02 sensor tool that I could modify as a PFP adjuster tool.
The socket is a 22mm with a 1/2 square drive.
$30 later I walked off the truck with my prized possession.



I cut the tool to fit under my bars.
I ended up going down to 5mm on the socket part.



Here's the socket on the fork. There's a hole in the 1/2 drive side that I stick a screwdriver into for leverage.
Works like a champ.

 

[shang]

That's awesome!

I drew one up and printed it from ABS plastic. It works great but it is just plastic so it will likely break at some point so I'd like a permanent solution like yours.

 

[MNKeith]

$30? Ouch.

http://www.harborfreight.com/3-8-eighth-inch-offset-oxygen-sensor-wrench-97177.html

 

[liamthom]

Molding and casing it might work

 

[Dirt Dud]

Great Idea ! I will own one for sure .

 

[gasgasman]

$30? Ouch.

http://www.harborfreight.com/3-8-eighth-inch-offset-oxygen-sensor-wrench-97177.html

I have an O2 sensor socket like that.
It would not fit down into the fork cap.
Plus, I wanted a 12 point socket to allow for a wider range of turning.