Husaberg te 300 2012 jetting

A

adriano.ro

New member
I'm new owner of Husa and I'm playing with jetting now.
Now I have 38p, N2ZJ@3 168 pilot as 1.5, temp 10C-25C, alt 800m.
I like how bike run but I have some needles and I want to know witch one of those give best torque for my bike,and the needle ar: N8RW,N8RK,N2ZL,N2ZK,N3CW. How will run n3xx vs n8xx?

If someone have other needle with good results, can post here.
 
All the needles you listed are the same taper profile

In 1/2 clip variations from leanest to richest they are...
N89x=leanest
N3Cx
N3Ex
N8Rx
N2Zx
N4Dx
N3Vx
N4Ax
N6Mx=richest

I agree with ScottyR. Suzi needle will get you close fast!
 
NECJ is the most used needle on ktm,very good report,I just ordered one from motocrosscenter.com. , but wath I found also is N3CH with good results.
 
My experience of the n3 vs ne needles the ne is more linear power the n3 is similar on the bottom with a harder (more fun!) hit when you are on the pipe
 
Update: p40 necj.3 main 165. Very smooth power delivery. But I have some hesitation on wide open throttle,sounds clean but has about 1-2 sec of that pause. No sign of topical lean sound booooaaa. When I have tested the needle was a bit cold,under 10C ,and air screw was only 0.5 tourn out.
 
You must log in or register to reply here.
Back
Top