Need to find Inner cartridge bushings-48mm marzocchi’s

I'm having the same issue with my Marzocchis, the bushing is almost dead :( rvangeel, please give feedback if the Sachs CC bushes fit?
 
I have contacted Richard Wilson, he has one used cartridge with good bushing that he is going to sell me. I only need the one bushing anyways. I contacted Zip Ty racing also, they seemed liked they would be able to get a set. The guy I talked to had to ask Ty, but he was not there that day.


Sent from my iPhone using Tapatalk
 
is the size of the bushing and fork parts 36 od 34 id 15 long 1mm in thickness , did the non adjustable ppf cc 48 use the same bushing
 
need the dimensions of the ics ppf spring id od length spring wire diameter thanks not found if marzocchi italy are still going
 
Here is some more info regarding the sizes and a video showing how the 0.1mm larger diameter does not fit inside the cartridge.

Just to be clear, the racetech bushings do not fit. I have found a used bushing that is in good condition and will install it when it arrives next week.

IMG_8988.JPG
IMG_8987.JPG
IMG_8989.JPG

https://youtu.be/ykj2cDIzpvQ



Sent from my iPhone using Tapatalk
 
rvktm said:
need the dimensions of the ics ppf spring id od length spring wire diameter thanks not found if marzocchi italy are still going
Click to expand...



102mm long
26mm OD
19mm ID
3.6mm wire dia

The springs on these cartridges (the forks have enduro engineering stickers on them) seem to have been apart before so I don’t know if these are stock springs. There is a part number on them... 341620 on one coil and then a 14 on the next coil.

IMG_8991.JPGIMG_8992.JPGIMG_8993.JPGIMG_8995.JPG

IMG_8994.JPG


Sent from my iPhone using Tapatalk
 
I'm actually now thinking about to find someone who can machine the piston for me so I could use the 35x15x1 or even 35x15x1.5 since small KTMs use this size. Would be one time job to use alternative available bushes.
 
thanks mate think the 14 is the spring rate found a suspension site in germany that lists ics springs the softest thay do is 14 dont no what the std rate fitted to the mar 48s . iv found a slide bush 36 od 15 wide 1mm used on mar 35 and ktm 50 /65 forks skf do them under a tenner each . a good tip i got of beta rr fb is to use ktm /wp fork protector rings/ bush 2.50 each uk
 
Last edited:
i see your problem thinking hard ish plastic tube bored to a good fit on the bush then use a two or 3 leg stone hone or ball hone to take the .1 out or jubilee clip!!!! to hold the bush to hone good luck
 
the ics springs in your forks are the same as kyb showa 18.9 id 26 od 100 long ln 142 161 176 190 210 rate. rw told me that 014 017 had sorter softer ics springs
 
You must log in or register to reply here.
Back
Top