OEM clutch

[Getoviq95]

What brand is the OEM clutch for gas gas ,especially friction plates ? I have one from Adige (italian brand) and i think ,that this is the oem gas gas clutch .

 

[frankinberg]

It's a honda clutch I think cr 250 not sure what year

 

[Getoviq95]

My friend said me ,that this is the OEM clutch .He has seen the same discs in brand new gas gas .

 

[Moto7man]

Honda Clutch Pack Conversion

See post #42 and #46 on this thread. Honda fibers are 2.98mm and the GasGas Fibers are 2.75mm. (2011 GasGas)What are the measurements for your aftermarket plates?

http://www.gasgasrider.org/forum/showthread.php?t=15126&page=5&highlight=Honda+clutch+conversion

 

[Getoviq95]

My plates are around 2,80mm (haven't micrometer) .I bought it from gas gas dealer and my question is whether these are
the OEM(Original Equipment Manufacturer ) gas gas plates .I'm almost sure they are .I think ,that the oem plates will work better than aftermarket .

 

[Moto7man]

My plates are around 2,80mm (haven't micrometer) .I bought it from gas gas dealer and my question is whether these are
the OEM(Original Equipment Manufacturer ) gas gas plates .I'm almost sure they are .I think ,that the oem plates will work better than aftermarket .

Measure them,if they are around 2.75mm then you know they are probably close to GasGas Oem size.

 

[Moto7man]

Adige lists clutch plates for older Gassers and Hondas, try their catalog link below.


http://www.adige.eu/public/ENG/catalog/result.asp