parts crossover - rear brake pedal?

[stainlesscycle]

the crossover says 'kx with modification' which model/year kx? there are several different ones....
and modification i'm assuming is drilling and bushing the pivot? (for 2000 gasgas)

 

[stainlesscycle]

i bought a 98 kx250 rear brake pedal, will see show it works out. at the race today i paid close attention to a a few different models rear brake pedal - it sure does look like the modern yz125 pedal would work (and the wr250 one too..) - i'm gonna take my broken pedal to the shop and compare. will report back!

 

[geno]

and why is it that we are not buying/ supporting the oem parts chain? i,m sure these parts are still avail.

 

[stainlesscycle]

$91.60 for oem lever only
$150.38 for oem lever with tip, spring, pin, bushing etc.

$20 for used kx pedal complete.

i have broke 2 brake pedals this year. $20 versus $150.38 is good enough reason for me.

 

[stainlesscycle]

$20.00 used kx250 pedal + $.93 bronze sleeve bearing from mcmaster + o-rings + washers = better pedal than original.

the 1998 kx250 pedal i bought has pivot tip (there are later mdels without it..) LOOKS significantly stouter than the gg pedal. it's significantly larger in the 2 places i broke gg pedals. (about 1/2" back from front clevis pivot, and bigger area where pedal pivot goes through. i don't know if it's better overall, but we shall see how long it lasts.

 

[noobi]

$20.00 used kx250 pedal + $.97 brass bushing from mcmaster + 2 o-rings + 2 washers = better pedal than original.

the 1998 kx250 pedal i bought has pivot tip (there are later mdels without it..) LOOKS significantly stouter than the gg pedal. it's significantly larger in the 2 places i broke gg pedals. (about 1/2" back from front clevis pivot, and bigger area where pedal pivot goes through. i don't know if it's better overall, but we shall see how long it lasts.

What are the dimensions of the parts you added, and could you please add photos..

 

[stainlesscycle]

i bought a bronze sleeve bearing o.d. 16mm, i.d. 12mm, 20mm long. it was $.93..

http://www.mcmaster.com/#6658k16/=9gof6r


pressed it in. greased up shaft. installed.

i used o-rings and regular m6 washer to take up a small space under the bolt (25mm bearing would have not needed this..)

this is for the earlier style brake lever mount..


total time to mount/modify under 5 minutes.

 

[smallpuffydog]

i bought a bronze sleeve bearing o.d. 16mm, i.d. 12mm, 20mm long. it was $.93..

http://www.mcmaster.com/#6658k16/=9gof6r


pressed it in. greased up shaft. installed.

i used o-rings and regular m6 washer to take up a small space under the bolt (25mm bearing would have not needed this..)

this is for the earlier style brake lever mount..


total time to mount/modify under 5 minutes.

Thank you for that link!

 

[motogroove]

Thanks for the info.

FWIW, doing a little reverse lookup...
98 KX 250 brake pedal is also the same as
98 KX 125
97 KX 250
97 KX 125


43001: LEVER-BRAKE,PEDAL - $86.55 over at Ubiquitous Internet Moto
92081: SPRING
92093: SEAL
92151: BOLT