Jakobi
Super Moderator
Hi all,
Just pulled the rear wheel for the first time on my new EC300. What a pain to get the axle out. Nothing like the old Yammi that pulls out by hand. I'm hoping this will change in time.
What I did notice though, was that the inner guide (sits between the bearing ins the hub) had some movement to it. Like if I stuck my finger in a could push it side to side a bit. A bit more than I have been able to do with other bikes.
This makes me wonder if the bearings have been fully seated? or is this just the way the gassers are?
Anyone wanna share some light?
Cheers!
Just pulled the rear wheel for the first time on my new EC300. What a pain to get the axle out. Nothing like the old Yammi that pulls out by hand. I'm hoping this will change in time.
What I did notice though, was that the inner guide (sits between the bearing ins the hub) had some movement to it. Like if I stuck my finger in a could push it side to side a bit. A bit more than I have been able to do with other bikes.
This makes me wonder if the bearings have been fully seated? or is this just the way the gassers are?
Anyone wanna share some light?
Cheers!
