Rear wheel spacers dimensions needed

[mrfreezer]

Hello guys... would anybody be so nice and measure dimensions of rear wheel spacers for ec 250 2008? I want to have them machines because it is difficult to buy those in Slovakia... thanks a lot


Edit: as i have figured out from used bearings and seals all spacers 20mm ID, right spacer 25mm OD, left spacer 25/32 mm OD, spacers between two bearings is 20x42x2mm. So i need to confirm these dimension and add lenghts for all 4 spacers.. thanks a lot

 

[Neil E.]

Here is the dimensions I used to make my own spacers (measured in inches). These dimensions have been rounded off a bit, but you can probably deduce the original metric sizes. To convert divide the inches by .03937 for mm.

If you have trouble I can dig out the original spacers and measure them for metric dimensions. These fit 2011, should work for other years.

 

[(F5)]

I bought some aftermarket ones off some French site by searching for the part numbers. Can't remember. But well made and hard anodised.

 

[mrfreezer]

Neil... thanks a lot.. it helped... I have converted it... can anybody check those other spacera for me?

 

[swazi_matt]

doesn't the washer have a step on it?

 

[cbutler]

Yes it does

 

[Neil E.]

doesn't the washer have a step on it?

That's a good point. There is a small step that's intended to keep the spacer from falling out when the wheel is removed. I found them to be a nuisance. They push out some of the grease that I fill the lip with so I omitted them.

I'll dig out the originals, but I'm sure I machined the step mostly off for the same reason.

 

[mrfreezer]

guys... can anybody measure the long spacer in the middle of the rear hub? mine is damaged so I can not figure out how long it have to be... the damaged one is 100.5mm long

 

[swazi_matt]

I won't be having my wheel off for a while, but surely the dimension can be measured from the inner wheel bearing race on each side?

 

[mrfreezer]

thanks, but I need to have new spacers done before I start to disassemble my wheel

 

[(F5)]

Indeed the bearings will be flat inner race to outer side