Well after filling it mud and water over Christmas a rebuild was on 
So in the end I stripped back to bare frame had had it powder coated
satin black. Motor wise it had new bearings and a Wossner piston kit
Got the motor slotted back in but only got time to run it 2 weeks ago at
a local practice day. All went well and it goes very well now esp not the
power valve rod in in one piece
I was due for a shoulder opp on the Tuesday so i entered a local Enduro
on the Sunday ive this one it before but i have to top up before the 2
hours is up.
So to sort that out i got me a new CLARK 3.2 gallon jobbie
I ended up 8th out of 66 in my class and that with 1 good off a re fuel
and helping pull a bike off someone so i recon not bad. So when im back
on the bike when the shoulder has healed top 5 might be on the cards ....
So in the end I stripped back to bare frame had had it powder coated
satin black. Motor wise it had new bearings and a Wossner piston kit
Got the motor slotted back in but only got time to run it 2 weeks ago at
a local practice day. All went well and it goes very well now esp not the
power valve rod in in one piece
I was due for a shoulder opp on the Tuesday so i entered a local Enduro
on the Sunday
ive this one it before but i have to top up before the 2 hours is up.
So to sort that out i got me a new CLARK 3.2 gallon jobbie
I ended up 8th out of 66 in my class and that with 1 good off a re fuel
and helping pull a bike off someone so i recon not bad. So when im back
on the bike when the shoulder has healed top 5 might be on the cards ....
