S Scruse24 New member Nov 9, 2015 #1 Looking for a linkage guard for '13 300. I saw the scorpion(emporer racing), but it lowers the rear 3/4"
Looking for a linkage guard for '13 300. I saw the scorpion(emporer racing), but it lowers the rear 3/4"
S shang Member Nov 9, 2015 #2 I made one. It gets used pretty often. It's just some UHMW plastic sheep from McMaster.
S shang Member Nov 9, 2015 #4 It's really slippery plastic so it doesn't hang up on anything. It's really easy to work with too. I just cut it with a razor knife.
It's really slippery plastic so it doesn't hang up on anything. It's really easy to work with too. I just cut it with a razor knife.
S Scruse24 New member Nov 10, 2015 #5 http://www.mcmaster.com/#standard-plastic-sheets/=zqplcx That the one you bought? 12x12?
S shang Member Nov 10, 2015 #6 McMaster won't let you link the page. I did UHMW IN 1/2 inch thick. 12x12 sheet. Then I think I just cut it in half. Rounded the rear corners, heated it with a heat gun on the end and curved it a little, then sandwhiched it between the rear skid mount and the skid plate.
McMaster won't let you link the page. I did UHMW IN 1/2 inch thick. 12x12 sheet. Then I think I just cut it in half. Rounded the rear corners, heated it with a heat gun on the end and curved it a little, then sandwhiched it between the rear skid mount and the skid plate.
K kdxkid New member Apr 19, 2018 #9 shang said: Sorry!! I was hasty writing that! 1/4 inch thick. Not 1/2!! Click to expand... Any chance you have some updated pictures of this? I want to give this a go for my 2011
shang said: Sorry!! I was hasty writing that! 1/4 inch thick. Not 1/2!! Click to expand... Any chance you have some updated pictures of this? I want to give this a go for my 2011
