Hi, i am a newbie on this forum and looking for some advice on my first ever bike. I bought a 1999 ec250 endoro with a few problems. Ignition stator broke, play in crank shaft, a was wondering if it is an easy job to do bearings myself and is it costly for bits. Need a cheap as possible repair or bike has to go wife says lol.
ec250 engine
- Thread starter lordhawes
- Start date
Left hand. Same puller as a YZ250.
Read this thread, will answer most of your questions.
http://www.gasgasrider.org/forum/showthread.php?t=14730
Get a seal kit, gasket kit and bearings from a local supplier.
Organize and label your hardware as you disassemble. I have a fleet of small resealable containers that are invaluable for things like this.
Keep a parts manual handy, you will need it to reference assembly.
I'm somewhere over halfway done doing mine. I'm fairly mechanically inclined but have never done this procedure before. Not too bad so far.
Read this thread, will answer most of your questions.
http://www.gasgasrider.org/forum/showthread.php?t=14730
Get a seal kit, gasket kit and bearings from a local supplier.
Organize and label your hardware as you disassemble. I have a fleet of small resealable containers that are invaluable for things like this.
Keep a parts manual handy, you will need it to reference assembly.
I'm somewhere over halfway done doing mine. I'm fairly mechanically inclined but have never done this procedure before. Not too bad so far.
