Anyone using a g2 throttle tamer? I have an 18 xc 250 and it seems no matter where i set my power valve, when the bike comes on the pipe it hits pretty aggresively. Raced in some super slick mud and even with the p.v. set at 1 turn out i had to be gentle when gassing it or there would be lots of wheelspin.
G2 throttle tamer?
- Thread starter Greatdane
- Start date
Jakobi
Super Moderator
I have always loved the 250 engine, and always used the G2 quick pull.
Some of that is the nature of a 250. It has a slacker bottom end, yet makes similar peak hp.. that difference is made up for as the engine comes onto the pipe.
In super slick conditions everyone gets wheel spin. The best way around it is to upshift and carry momentum. That way you can use bigger throttle inputs, dampened with some clutch slipping, lower rpm which gives a softer delivery, and let the torque carry the bike. If momentum is lost it's hard to get going again, especially if fighting gravity!
In general I find that the clutch is what brings a 250 together. It allows you to utilise the bottom end power for smoothness, and then feed in the excitement as needed. I use the clutch to boost the revs into the band, yet control the hit to the ground. Bit like feathering as you take off vs just dumping the clutch.
Ive got the jetting sorted out. 175 m 40 pilot n3ch needle and have a rk tek cut head. My bike runs great and is a rocket. Decent torque too. Been riding 250 2 strokes for 30 years. Just seems like the transition from torqey to full on oower is a little abrupt. Not really complaining just thought maybe thr throttle tamer might do the trick.
Jakobi
Super Moderator
Throw a Suzuki needle at it...
The N3 series are a dual taper that tend to transition pretty hard between bottom and top. The NE series have 3 tapers and supply a bit more fuel making for a more linear delivery.
