need pics of kickstand

boostedte37

boostedte37

Silver Level Site Supporter
got my new used kickstand in today and something is not panning out with it, some already installed pics would be a big help.
 
here is the kickstand installed but bolts not completely tight
blackberry173.jpg


the stand appears to be to far inward over rear tire

blackberry171.jpg
 
Mine looks the exact same way and doesn't seem
to case a problem except that it juts the # plate when retracting, I've seen some pics of them folding up completely outside the sidecover too. Maybe your and mine are bent a bit in.... As I said it appears to cause no issues and doesn't hang on my leg when stretching back
on the bike
 
Fred1956 said:
Mine looks the exact same way and doesn't seem
to case a problem except that it juts the # plate when retracting, I've seen some pics of them folding up completely outside the sidecover too. Maybe your and mine are bent a bit in.... As I said it appears to cause no issues and doesn't hang on my leg when stretching back
on the bike
Click to expand...

Mine does the same. You can bend the side plate screw tab on the subframe out the pull the side cover out a little. It will get knocked back in after a crash ot two so you need to keep an eye on it.
 
thanks for the replies, I like the way it tucks behind plate so I'll go with it like it is, it doesn't contact the plate going up or down and I assume the stand will not stay in down position on its own by design.

blackberry175.jpg
 
You must log in or register to reply here.
Back
Top