Pulled off my right side PV cover to investigate WOT performance issues. I found the allen head retaining bolt had come loose and was laying next to the push rod hole. The flapper pivot rod was sticking out about 1cm. THE WASHER IS MISSING! Looks like it fell down the hole. I estimate I ran at least 100mi of very hard riding under this condition....maybe more. Any advice on how to proceed would be greatly appreciated.
Power Valve Dilemma
- Thread starter gasIdaho
- Start date
GMP
Active member
Drain the oil, pull the side cover, and go fishing with a magnet. If the washer got caught in anything by now you would know it. There is a lot of area in the bottom of the primary cover where it could sit and probably is. Also, are you the first owner? If not, maybe the previous owner never reinstalled the washer and loctited the bolt after a top end job.
Drained the oil and found metal shards and a small flat piece of metal slightly curled on one edge. It was stuck to the magnetic drain plug. This is probably the washer...I hope!! I also pulled off the right side engine cover. Had a very good look around and all seems to be fine. All gear teeth look good. All bearings that I could get to were good. Going to slap her back together after I get some new gaskets and change the oil after the end of the next 3-4 rides....flush out as much lingering stuff as possible
