2010 clutch install..?

[blanc]

hi all. I am installing my stock clutch after using a rekluse. Does anyone know the correct plate order and have a parts diagram?

 

[Stoby]

Not sure on 2010 but my manual shows 8 fibers 7 steel
Stoby

 

[GasGas]

You should start with a fiber plate and end with a fiber plate. There should be a steel between each fiber plate. It's that simple.

 

[blanc]

Thanks, its more the location of the washers on the basket I am confused with, but looks like ill get there, ta for the advise

 

[stainlesscycle]

if hub and basket are removed:
in this order
spacer washer(thrust washer)
2 needle bearings and sleeve
basket
spacer washer(thrust washer)
hub
lock washer
nut

- both spacer washers should be the same thickness on 2010 i believe



then
plates
pressure plate
springs
cup washers
screws


if throwout bearing was removed:
(from inside out)
pushrod holder
throwout bearing
throwout washer
pressure plate
circlip