Brake parts

[SS109]

Bike is an 2011 EC250. Noticed my rear brake making some noise and was trying to figure out why. Noticed a lot of play so I want to replace all the pins/bolts and the rubber boots. Can someone please confirm what other bike(s) uses the same caliper setup? I've read about CR250 parts work on some years but what years of CR250?

 

[RudolfHucker]

Is that a Brembo or a Nissin caliper. Sorry, new to GasGas.

If it's a Brembo, a similar thread on the KTM forum pointed at Honda parts as, for some reason, Brembo won't sell the pins on their own.

Honda part numbers given were:

45131-HAS-672 (long one) and 45131-166-016 (short one)

 

[dANbOT]

There's probably info in one of the "crossover parts" threads, but:
My 2007 CR250 calipers matched my 2014 EC300, that line of CR brakes should run from 2007 back to 2005 for sure, probably to 2002. Some part fiche searching should confirm this.

 

[SS109]

Nissin front and rear.

None of the crossover threads I have read specify exactly what year Honda, or other brand, parts crossover for the locating pins, brake retainer pin, or the rubbers.

 

[Jakobi]

I have ordered Honda parts to do my rears on my 2010 (same as 2011). I can't remember if I posted the parts or saved the info anywhere though.

I'd probably go about looking up crossovers on the rear pads, and then draw the assumption that the calipers and carrier pins are probably the same.. They will have been used on Suzuki DR's, Yamaha WRF, Honda CR/F etc..

This shoud.. (not confirmed).. work: https://www.partsfish.com/oemparts/a/yam/500456bbf8700209bc793183/rear-brake-caliper

 

[AZRickD]

Those are Honda CR250 components. Early 2000s (possibly late 1990s) vintage.

Pins and other components are standard stuff

Take the pads, pins, etc to your local shop and they will match them up.