Marzocchi 48 advice

[Fred1956]

I need to make a tool to get into the inner chamber .

I started with a KYB?? (they say 35mm but mine is 36mm) one like this http://racetech.com/images/TFCT_600.jpg and then machined it out to 26mm OD x 6.25mm deep on the bottom side. Lots of bite and clearance.

 

[Diggs345]

I started with a KYB?? one and then machined it out to 26mm OD x 6.25mm deep on the bottom side. Lots of bite and clearance

I was going to have a go at making one , my phase converter just died on the mill though , I'll have to wait for the one I ordered now .