darren
New member
Hi all, just looking for some advice regards my carburator on EC250 1998
Removing the slide i was checking the needle and it apears to have a shiny flat spot on the tip. I assume this means that it is worn. Am i correct?
The bike runs fine at all speeds (sometimes dies out at idle)
The needle is a N1EC
Slide #7
Jet 178
Carb PWK38 S54A3 LL
Basically need to know if i have to get a new needle. If so do i change the main jet also?
Removing the slide i was checking the needle and it apears to have a shiny flat spot on the tip. I assume this means that it is worn. Am i correct?
The bike runs fine at all speeds (sometimes dies out at idle)
The needle is a N1EC
Slide #7
Jet 178
Carb PWK38 S54A3 LL
Basically need to know if i have to get a new needle. If so do i change the main jet also?
