pv bearing size

[stainlesscycle]

hi, can someone post pv bearing sizes/numbers - wanted to order some/check if i have them in stock for a rebuild, and don't have the numbers handy - i know there's 2 of one size, and 1 of the other.... thanks!


i did some quick research - is it 608 (2) and 6000 (1) - open bearings i assume ?

 

[rpduc]

Sorry, don't remember seeing actual size stated but they fit Rollerblades!

I do know that the outside bearing on the left side is sealed. I think both of my left side bearings are sealed, but the Powervalve Tech article with the exploded view shows only the outside one sealed.

Right one is open.

 

[Jakobi]

All my bearings from stock were sealed. I replaced them all with sealed bearings too. Not sure if I held onto the ones I replaced or not.. I'll have a look down the shed later.

 

[Spitfire77]

Bearings

I have just replaced mine recently. On the stock setup the 2 small bearings were only sealed on one side. It was the same with the larger bearing as well. I replaced them with bearings that were sealed on both sides. Everything worked well for about 50 miles of riding until my PV stuck in the closed position. I have not cracked it open yet to set what went bad. Hopefully the new bearings are not the problem.

2004 EC 300