Throttle Assembly

[kyton]

Is there any crossover or universal throttle assembly that can be used. I took mine off to clean as throttle was sticking. This thing was full of grit and old grease from previous peeps. When I remove the bottom section, it broke in half. Proberbly from being over torqued on the bars.

 

[swazi_matt]

Hi Steve
If you are looking for the whole assembly i would think that any bike would work, but you may want to match the pulley-wheel diameter to get the same throttle response. I think the GG ones are domino which is the same as the ktm's

If it is only the lower bracket it may be easier to get one machined up?

 

[Jakobi]

Its just a basic domino 2T throttle housing. I have 2 x stock throttle houses that I replaced with G2 Quick pull systems. Not sure what postage from Australia to South Africa would be like though.

From G2 complete housing + tube + cam. Can still use your previous stock cams too. http://www.g2ergo.com/store/2-stroke-quick-turn-system/

 

[djroggen]

I have a few lowers because the upper breaks usually. I would ship it for pry $10 total.

 

[kyton]

Thanks for the responses. I did find this http://www.motoward.com/images/34 throttle assbly.pdf (the one called vuma)for 145zar, apporx $13 not sure if it will work though.

So far i have epoxied it, will let it set for a day or two before i hopefully venture out on my first "funduro". Also found a guy that can wels Pewter, my issue is the groves in the bottom as the cam sits in it as well.

 

[cbutler]

Husky is a direct crossover.

 

[gassergrant]

I used my cr one when my one broke I've seen the same throttle on ktm's , I bought a 2stroke replacement to get me out of trouble and it's no good so I woułd becarful what you get or you will find you buy twice